ISO INTERNATIONAL STANDARD 11148-3 Second edition 2012-12-15 Hand-held non-electric power tools - Safety reguirements - Part 3: Drills and tappers Machines portatives a moteur non électriqueExigences de sécurité- Partie 3: Perceuses et taraudeuses Reference number ISO 11148-3:2012(E) ISO @ISO2012 by IHS under No reproduction or networking permitted without license from IHS Not for Resale ISO 11148-3:2012(E) COPYRiGHTPROTECTEDDOCUMENT ISO2012 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 · CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2012 - All rights reserved No reproduction or networking permited without license from IHS Not for Resale ISO 11148-3:2012(E) Contents Page Foreword ..iv Introduction 1 Scope 2 Normative references 3 Terms and definitions. 3.1 General definitions. 3.2 Definitions related to drills and tappers 4 Safety requirements and/or protective measures 4.1 General 4.2 Mechanical safety. 4.3 Thermal safety.. 4.4 Noisereduction.. 4.5 Vibration.. 6 4.6 Materials and substances processed, used or exhausted. 6 4.7 Ergonomics. 4.8 Controls . 5 Verification 8 5.1 General conditions for tests. 5.2 Noise 8 5.3 Vibration 8 5.4 Unintentional start. 8 5.5 Power tool construction 5.6 Structureofverificationofsafetyrequirements 9 6 Information for use 9 6.1 Marking, signs and written warnings. 9 6.2 Instructions handbook... 10 6.3 Operating instructions. 15 6.4 Data 15 6.5 Maintenance instructions 16 Annex A (informative) List of significant hazards.. ..17 Annex B (informative) Examples of drills and tappers covered by this part of Iso 11148 .. ..19 Annex C (normative) Symbols for labels and signs.. .21 Annex D (normative) Additional safety requirements related to internal combustion engine powertools 23 Bibliography. 27 ili e with I: ed without license from IHS Not for Resale